Author: Ant

  • 3D Print Connectors

    3D Print Connectors

    When creating a multi-part 3D print there are a number of common ways to join the pieces, for something designed to be semi permanently fixed but still openable we can embed threaded inserts in the print. It ends up looking something like this:- You can then use a regular bolt to attach whatever is required…

  • PSA: Get a Mask!

    PSA: Get a Mask!

    If you’re new to 3D Printing (FDM) you probably have read conflicting information regarding if the printing process produces fumes that should be considered dangerous. I’ve seen a lot of mentions that if you’re printing PLA then you need not worry unless you’re constantly printing as the levels aren’t of levels that could do you…

  • Budget Friendly Audio

    Budget Friendly Audio

    Iv’e just found this little wireless mic set. If you’re looking for a quick, low cost way to get close up audio when recording video using your phone, this might be a great choice for you! Normally when asked I’d suggest the Rode Wireless Go II to people looking for a wireless mic set: However,…